Enclosed seems very crude and too simplified, but at this point we could 
not come up with more sophisticated idea than those. Hope it helps you 
to start up this important job. 
		Sincerely, Toru 

A) Parameters measured during construction. You can glance them in our Web. 
   They would be used in early stages of calibration/analysis routines as 
   default values and/or to check the quality of measurements during runs. 
    - pmt gains (a few words X 160)  ("a few" = "5 - 20")
    - noise (a few words X 160)
    - pulse shape (gif)  (a few Kbyte X 160)
B) Parameters meausred online during runs.
    - pmt gains (a few words X 128)
    - pmt parameters (slewing parameters etc.) (a few words X 128)
    - TDC offset (a few words X 128)
    - TDC gain (a few words X 128)
    - ADC offset (a few words X 128)
    - ADC again (a few words X 128)
    - history (pmt assignments, HV values etc.) (a few Kbyte ??)
C) Parameters obtained offline in calibration/analysis phase.
    - pmt gains (a few words X 128) 
    - pmt parameters (slewing parameters etc.) (a few words X 128) 
    - TDC offset (a few words X 128)
    - TDC gain (a few words X 128)
    - ADC offset (a few words X 128)
    - ADC again (a few words X 128)
    - history (parameter changes during calibration/analysis) (a few Kbyte ??)